Thermal protection composites based on phenol-formaldehyde resin and reinforcing fibers
Abstract
This study presents the development and experimental investigation of composite thermal insulation materials intended for application in solid-propellant rocket motors. Test specimens were fabricated using the hand winding method with phenol-formaldehyde resin as the binder and four types of reinforcing fabrics: carbon, basalt, glass, and silica. A comprehensive set of tests was conducted, including tensile strength (up to 420 MPa), compressive strength (up to 310 MPa), Brinell hardness (ranging from 29 to 43 HB), thermal conductivity (from 0.045 to 0.39 W/(m·K)), and thermal resistance under direct high-temperature gas exposure (rear surface temperatures from ~250 to 350 °C). The results demonstrated that composites reinforced with carbon fabric exhibited the highest mechanical strength and heat resistance, whereas silica-based composites showed the lowest thermal conductivity and the best thermal insulation performance, making them suitable for internal thermal protection of combustion chambers and nozzles in rocket propulsion systems.
Recommended Citation
M.N., Meiirbekov; M.Sh, Sadykov; M.S, Janikeyev; A.B., Kuandyk; N.B., Yesbolov; and M.N, Nurzhanov (2025) "Thermal protection composites based on phenol-formaldehyde resin and reinforcing fibers," Eurasian Journal of Physics and Functional Materials: Vol. 9: No. 4, Article 6.
DOI: https://doi.org/10.69912/2616-8537.1263
References
Downloads
Published
Issue
Section
License
The Eurasian Journal of Physics and Functional Materials is an open-access journal. Articles published under the Creative Commons Attribution 4.0 International License (CC BY 4.0) may be shared, redistributed, and adapted, including for commercial purposes, provided that the terms of the license are followed, including appropriate attribution to the original authors and source.
License: https://creativecommons.org/licenses/by/4.0/
Copyright ownership and publication rights are governed by the terms applicable to each article and the relevant author agreement.


